Quarter Panel to Rear Roof Bracket - LH - 68-70 Dodge Plymouth B-Body including Dodge Charger, Daytona, Super Bee, Coronet, Plymouth Road Runner, GTX, Belvedere and Satellite.This reinforcement bracket is mounted to the quarter panel and to the rear of the roof rail just like original.
Accurate reproductions of original quarter panel reinforcement. Commonly destroyed during 1/4 panel removal or missing from previous repair. This brace supports the edge of the quarter panel with proper alignment holes and trim hole provision. It is very common for the quarter panel to develop a stress crack near the end of the drip rail when this reinforcement is missing.
Made from OE gauge steel, this quarter panel reinforcement has the same shape, bends, holes and curves, just like original. Arrives EDP coated to protect against rust and corrosion prior to installation.
LH = Driver Side
Replaces PT# 2603 154-5, 2838 446-7
Auto Metal Direct is a team of true car guys with years of experience in sheet metal reproduction, car restoration and paint/body work. We believe that quality is not subjective! Our mission is to provide the best customer experience for the Ford, Mopar and GM classic car markets - both in products and in service.
Our panels are made from proper gauge steel and include all correct-as-original clips, tabs, flanges, bends and seams. Each time a prototype body panel comes off of a new tooling, we test fit it on a car. The marked up prototype is then used to change and improve the tools, and a new prototype is produced. This procedure might be repeated multiple times but, once the part is finally approved, you can be assured of a quality part.
| Make | Model | Years |
| Dodge | Charger | 1968 - 1970 |
| Dodge | Coronet | 1968 - 1970 |
| Plymouth | Belvedere | 1968 - 1970 |
| Plymouth | GTX | 1968 - 1970 |
| Plymouth | Road Runner | 1968 - 1970 |
| Plymouth | Satellite | 1968 - 1970 |
| Brand | AMD |
| Height | 2 in |
| Length | 7 in |
| Weight | 0.2 lbs |
| Width | 4.5 in |
