DMT Set of inner taillight gaskets for a 1968 Dodge Charger
1968 68 Charger
The molded rubber housing to body gaskets are not being reproduced. SoffSeal does make a single thickness black foam gasket. The problem is the area in the housing where this gasket sits is very deep at the top and very thin at the bottom. A single thickness gasket doesn't work.
Material
.125" gray foam rubber lense to housing gaskets - exactly like OEM
Included are (8) white poly foam gaskets for the studs of the 4 cylindrical taillight housings.
In 1977, at 15, my first car was a 70 Barracuda I bought for $600 from my dad's co-worker at Chrysler Huber Ave Foundry. Tawny gold, 318, hub caps. Before I could "legally" drive it it had headers and a 4bbl. Had a couple other Mopars after this as a young man.
25 years later it was time to get another Mopar. After looking for 2 years I found a 1971 B5 blue Challenger right here in Michigan. 318 and hubcaps again. This time it cost over 10x as much, $6500. Didn't take long to add wheels, new leaf springs, 340 6bbl, etc. A year or two later I decided to completely redo the car. Had it media blasted and painted B5 blue again BUT when I went to put it back together I found there were no good body gaskets sets for Mopars. The gasket making journey began.
In 2004 I first made a kit to redo my Non A/C heater box using a laser engraver/cutter that I had for another side business. I showed the guys on Moparts and quickly had a few orders. I obviously made all the gaskets for my car because I had all the parts for templates. Many parts fit the other E body models so I soon had all the E body gaskets, then more body style, then more heater box kits and the rest is history.
| Make | Model | Years |
| Dodge | Charger | 1968 - 2026 |
