Reproduction "Final Design" turn signal switch for 1967-71 Mopar A, B, C, & E-Body models without tilt wheel. This switch comes with metal connectors attached to the ends of the wires and includes the plastic connector for a solder and splice-free plug-in installation. 2-3/4" from outside of arm to outside of arm.
This switch is modeled after the final design by Chrysler Corporation who changed the design several times over the years. Note the wires on the actuator. Please verify that this switch is correct for your application before purchasing. Saginaw also produced a switch that was used in some of the the same models listed below. The Saginaw switch is radically different, as are the bolt patterns. These two switches are not interchangeable.
Note: Depending on what version of switch your vehicle used, and whether or not your switch has been replaced in the past, the actuator (turn signal cam) may be different on your old switch.
The Vehicle Fitment Guide is to be used as a general reference. The data has been provided by our suppliers and manufacturers and may contain errors or incorrect data. Always refer to a professional to verify correct fitment for your vehicle.
IMPORTANT: Electrical items are covered by a 30 day EXCHANGE ONLY WARRANTY. There are no returns or refunds on such items.
