Reproduction of the original Rallye Gauge panel and switch plate designed for use on 1970-71 E-body hardtop models. Original bezels that are scratched, damaged or covered in overspray can be very difficult to repair. The woodgrain finish on this aluminum bezels is not a decal. Each woodgrain panel utilizes screened print just like the originals. 4 switch design. Note: This panel is stamped from a flat aluminum panel, minor bending of panel is necessary before installation to get proper curvature in the corner area.
Dodge ApplicationsNote: Identification of gauge cluster is important. On 1970-71 models, the dash reset knobs protrude through the outer bezel of the gauge. This 4-switch version has provisions for the headlamp switch, wiper-washer switch and panel dimmer switch in the switch panel located to the left of the gauges.
| Make | Model | Years |
| Dodge | Challenger | 1970 - 1971 |
| Plymouth | Barracuda | 1970 - 1971 |
| Plymouth | Cuda | 1970 - 1971 |
| Height | 25 in |
| Length | 3 in |
| Weight | 2.19 lbs |
| Width | 7 in |
