Reproduction of the original Rallye Gauge panel and switch plate designed for use on 1972-74 Plymouth Barracuda, Cuda, and Dodge Challenger hardtop models. Original bezels that are scratched, damaged or covered in overspray can be very difficult to repair. The woodgrain finish on this aluminum bezels is not a decal. Each woodgrain panel utilizes screened print just like the originals. 3 switch design. Note: This panel is stamped from a flat aluminum panel, minor bending of panel is necessary before installation to get proper curvature in the corner area.
Dodge ApplicationsNote: Identification of gauge cluster is important. On 1972-74 models, the dash reset knobs protrude through the outer bezel of the gauge. This 3-switch version has provisions for the headlamp switch, wiper-washer switch and panel dimmer switch in the switch panel located to the left of the gauges.
| Make | Model | Years |
| Dodge | Challenger | 1972 - 1974 |
| Plymouth | Barracuda | 1972 - 1974 |
| Plymouth | Cuda | 1972 - 1974 |
| Height | 25 in |
| Length | 3 in |
| Weight | 4 lbs |
| Width | 7 in |
